Board Cutting Optimiser: measuring, estimating and worked-example guide

Niezawodny proces

Use Board Cutting Optimiser for practical measuring and estimating, with clear inputs, a worked example, site checks and result verification.

1. Take the measurements required by Board Cutting Optimiser and record the units beside each value.
2. Check site conditions, wastage, product coverage and manufacturer guidance before calculating.
3. Run the calculation and keep the unrounded result until the final ordering step.
4. Compare the result with supplier pack sizes, drawings and a second manual sense-check before purchasing.

Kontrole przed użyciem wyniku

• Are the source values current and entered in the correct fields?
• Are the units, decimal separators and signs correct?
• Have optional settings or assumptions been reviewed?
• Does the result look plausible when compared with a simple known case?
• Have you kept enough precision until the final step?
• If the result affects money, safety, purchasing or compliance, has it been independently checked?

Typowe błędy do uniknięcia

• Mixing millimetres, metres, feet or inches in the same calculation.
• Using drawing dimensions without confirming actual site conditions.
• Forgetting waste, laps, cuts, pack sizes or manufacturer coverage.
• Ordering directly from an estimate without a final supplier/specification check.

Praktyczny poradnik: measure estimate

Measure twice when the result affects ordering.

Apply waste only once and make the allowance explicit.

Round to purchasable pack or stock sizes only at the end.

Najczęstsze pytania